Customer Customization Yes Gas Water Heater Including Solenoid Valve Perfect for Commercial Industrial and Long Lasting

Customer Customization Yes Gas Water Heater Including Solenoid Valve Perfect for Commercial Industrial and Long Lasting

Product Description

An unattended tap can waste water and fuel long before anyone returns to the room. This 10L flue type instant gas water heater includes a 20-minute operating cutoff to interrupt an unusually long uninterrupted heating cycle, adding a practical safeguard for shared homes, guest properties, and staff facilities. The timer is one layer of protection rather than permission to leave the heater running. Water movement activates the interlock, DC 3V pulse ignition lights the harmonica-shaped triple burner, and 20 kilowatts of input pass through an oxygen-free copper exchanger. The unit delivers approximately 10 litres per minute at a 25-degree Celsius rise for one major outlet, while controls adjust output from 35 to 80 degrees Celsius. Dry-heat protection blocks unsafe operation without adequate water movement, and there is no tank consuming fuel between uses. The operating concept remains clear enough for occasional users while addressing the specific risk of a forgotten draw.

Specifications

The heater measures 590 by 340 by 180 millimetres and weighs about 8 kilograms net. Its 670-by-405-by-230-millimetre carton brings gross weight to approximately 9 kilograms. Rated thermal input reaches 20 kilowatts, efficiency is at least 85 percent, and nominal hot-water output is 10 litres per minute at the defined rise. Working pressure covers 0.02 to 0.8 megapascals, with activation possible around 0.015 megapascals. Temperature adjustment extends from 35 to 80 degrees Celsius. Heating and stabilisation each occur within 15 seconds under suitable conditions, and outlet overshoot is specified within 2 degrees Celsius. LPG versions use 2800 pascals and natural-gas versions 2000 pascals. DC 3V batteries power dual-pin pulse ignition, three G1/2-inch ports serve fuel and water, and a 90-millimetre chimney handles natural exhaust.

Technical Parameters

Installation Scenarios & Installation Precautions

Shared residences, guesthouse service areas, staff kitchens, covered utility corridors, and family annexes are appropriate when ventilation is permanent and one primary outlet is used. Mount the heater outside every sealed bathroom and away from bedrooms, staircases, or rooms lacking independent replacement air. The smoke pipe must lead outdoors through a predominantly vertical route, and a window, louvre, or door grille must remain available whenever the burner operates. Confirm wall capacity, leave 200 millimetres above and 150 millimetres on the sides, and avoid terminal positions subject to reverse wind. Test each fuel joint with soap solution, verify battery polarity, and allow the installer to confirm timer and safety operation during commissioning. The timer must remain accessible for service.

Features & Value Delivered to Global Buyers

The protection story combines the 20-minute cutoff with dry-burn prevention, flame-failure shutdown, overheat and water-pressure safeguards, low-pressure activation, dual ignition, and water-gas interlock. This gives distributors a concrete unattended-use message without relying on vague safety language. OEM choices include panel finish, housing colour, display, local warning text, branding, and carton design. MOQ begins at 100 pieces per model, samples allow regional review, and normal production starts after specification approval and deposit. A one-year warranty and free routine service components support dealer networks.

Safety Boundaries & Long-Term Use Reminders

The timer must not be bypassed for continuous commercial bathing or industrial water use. This heater remains unsuitable for sealed bathrooms, sleeping spaces, rain-exposed walls, or locations without permanent combustion air. Close the fuel valve after an unattended incident and investigate abnormal ignition before reuse. Keep towels and clothing away from the casing and chimney. Test the timer and protective shutdowns annually, replace batteries every twelve months, clean inlet filters in sediment-heavy areas, and inspect the exterior terminal for leaves, nests, or corrosion before high-use seasons.